Hardware Settings - Digigram VX442 Manuel Utilisateur

3. The third option, "AES/EBU In," connects the AES/EBU Out port directly
to the hardware AES/EBU input on the VX442. The left channel of the
AES/EBU In is routed to the left channel of AES/EBU Out and the right
channel of the AES/EBU In is routed to the right channel of AES/EBU Out.
4. The fourth option, "AES/EBU In (L/R Rev.)," functions identically to the
third option, except that the left and right channels are swapped.
Therefore in this mode, the left channel of the AES/EBU In is routed to the
right channel of AES/EBU Out and the right channel of the AES/EBU In is
routed to the left channel of AES/EBU Out.
5. Selections five and six connect the hardware analog inputs 1 & 2 or 3 & 4
(respectively) directly to the VX442's AES/EBU Out port. For example,
when "H/W In 1/2" is selected, any signal present at the IN1 port is sent to
the left channel of the AES/EBU Out, and any signal present at the IN2
port is sent to the right channel of the AES/EBU Out. This same behavior
applies to "H/W In 3/4" when selected.
At this point, you may begin to realize the versatility of the Monitor Mixer and
the Patchbay/Router, and the relationship between the two. You may want to
re-read this section and practice making some adjustments within the VX442
Control Panel software to become proficient in routing and mixing. You can
restore the default settings to use the card as a straight 6-in 6-out device at
any time - just choose the topmost option in each of the Patchbay/Router
columns.

Hardware settings

The Hardware Settings page of the VX442 Control Panel gives you control
over miscellaneous features of the VX442. To display this page, click the
"Hardware Settings" tab of the VX442 Control Panel.
VX442
User's Manual
17