Digigram VX442 Manuel Utilisateur page 15

The leftmost vertical column of Patchbay/Router page, "H/W Out 1/2"
connects this hardware analog stereo pair to one of six stereo sources:
1. The default setting, "WavOut 1/2" connects ports OUT1 and OUT2 to
your music software or Windows multimedia applet. In other words,
when music
"WavOut 1/2 VX442" it will be routed directly to the "hardware" analog
outputs 1 & 2 of your VX442.
2. The second option, "Monitor Mixer", connects ports OUT1 and OUT2 to
the outputs of the VX442 monitor mixer. For more information on the
capabilities of the monitor mixer, please see the section "Monitor Mixer".
3. The third option, "AES/EBU In," connects ports OUT1 and OUT2 directly
to the hardware AES/EBU input on the VX442. The left channel of the
AES/EBU In is routed to OUT1 and the right channel of the AES/EBU In is
routed to OUT2.
4. The fourth option, "AES/EBU In (L/R Rev.)", functions identically to the
third option, except that the left and right channels are swapped.
Therefore in this mode, the left channel of the AES/EBU In is routed to
OUT2 and the right channel of the AES/EBU In is routed to OUT1. Note
that this option is exclusively for monitoring/mixing purposes - the
AES/EBU In will not record in reverse when this option is checked.
5. Selections five and six connect the hardware analog inputs 1 & 2 or 3 & 4
(respectively) directly to the VX442's hardware analog outputs 1 & 2. For
software plays
User's Manual
audio to the
VX442
device named
15