YORKVILLE Paraline Série Manuel D'installation page 5

5. Positioning and Aligning the Brackets
An example is shown below of the rigging plates for the Left and Right side brackets. The cor-
rect way to mount the bracket is to keep the "lip" outwards on the top of the enclosure. As shown
in the second image below.
6. Installing the Brackets
Start from the upper-most enclosure and loosely position the brackets in place of the handles*, use the
bolts to help alignment - do not tighten until positioned correctly. Work from highest to the lowest in the
array. The installed brackets protrude on the TOP SIDE of the enclosures and mount onto the enclo-
sure 'above.' Repeat all of these steps for all enclosures in the array. When all brackets are in place
and aligned, tighten the nuts and bolts properly.
*NOTE: PSA1s manufactured after February 2012 use handles that include threading
and will allow the PSA1RIGKIT to mount directly, no nuts required.
7. PSA1FRAMEKIT
Once the PSA1RIGKIT brackets on the enclosures are in place (and tightened), the PSA1FRAMEKIT
(with the 10-point mounting holes) can be mounted to the upper-most enclosure, using the portion of
the bracket that protrudes. The groove of the PSA1FRAMEKIT bumper should mate perfectly with the
top PSA1RIGKIT. When the PSA1RIGKIT and PSA1FRAMEKIT have been installed properly and are
safe, the ratchet-strap around the array can be removed.
3