YORKVILLE Paraline Série Manuel D'installation page 3

Yorkville PSA1RIGKIT Installation
This is a step-by-step guide describing how to assemble your PSA1 rig for fixed installa-
tions. A Philips screwdriver and a C-wrench (or a right-angle impact-driver) will be needed
to complete this assembly. The PSA1RIGKIT includes all the hardware required to install
the kit on one PSA1. The PSA1FRAME1 and PSA1FRAME2 can fly a maximum of 4 cabi-
nets. Please follow the guidelines written in this document:
NOTE: The PSA1RIGKIT mounts directly onto the handles of the PSA1 enclosure. Steps
1-3 will not be necessary if the PSA1 being used was manufactured after February
2012. The newer enclosure's handles feature threading and will allow the PSA1RIGKIT
to mount directly without removal.
NOTE: A torque of 125 inch/pounds is recommended when tightening the hardware.
1. Removing Amp Module
Place the PSA1 on a solid flat surface such
as the floor or a sturdy table. Remove the
14 screws along the edges of the amplifier
module. When lifting the module out of the
cavity be cautious of the wire-harness at-
taching the module to the speakers.
2. Disconnecting Amplifier Module
Disconnect the wire-harness connecting the amplifier module to the speakers. The
connector is located close the module itself. Place the amplifier module and mounting
screws aside, in a safe and secure location.
1