YORKVILLE Paraline Série Manuel D'installation page 4

3. Preparing Enclosures for Brackets
To make it easier to remove the handle, position the PSA1 on its side. Insert the screwdriver
on each screw while holding the corresponding hex nut (found inside the PSA1) with your
C-Wrench. The hex nuts can be accessed without removing the foam on the inside of the
enclosure. (Do not remove the foam from the inside of the PSA1).
4. The Array
When all four screws, hex nuts and washers have been removed from each PSA1, ratchet-
strap the number of enclosures to be flown on level ground (as shown below). When strap-
ping the enclosures together, make sure they're aligned properly.
mounted on top of each other as well as for installing onto a PSA1FRAMEKIT. It is important to rec-
ognize the "L" on the LEFT side bracket for your PSA1RIGKIT. The LEFT bracket should be installed
on the LEFT side of the speaker facing the front of the cabinet. The "L" will be placed towards the
cabinet, leaving it unseen when properly mounted.
2
The PSA1RIGKIT includes a left bracket and a right bracket enabling the PSA1 enclosures to be
NOTE: PSA1s manufactured after February 2012 do NOT need to have the handles
removed to install the PSA1RIGKIT. The newer enclosure's handles feature built-in
threading and will allow the PSA1RIGKIT to mount directly.