Amplicord D1 Mode D'emploi page 11

Instructions for Use [E]
1. Turn on the device by sliding the switch to the lower position.
The device will vibrate lightly and the LED will blink green every
2 seconds. Should the battery levels be low, the LED will blink
green 8 times, in rapid succession.
2. Apply the device onto the softer part of the neck, with a light and
even pressure. The device will automatically begin functioning
upon contact with the skin.
3. Test the device by vocalising the letter A - E - I - O - U.
4. Adjust the tone of the voice created by the device, moving the
joystick to the left to decrease it or to the right to increase it.
5. Adjust the volume of the voice created by the device, moving the
joystick downwards to decrease it or upwards to increase it.
6.
Once you have reached the desired tone and volume, wait for
.
15 seconds without moving the joystick in order to let the device
automatically save your preferred setting. As the settings are
saved, the device will vibrate and beep once.
Maintenance and user rules
Maintenance will be carried out by the dealer.
We recommend cleaning the device on a weekly basis using a
cloth with a little amount of denatured alcohol. Do not use any other
type of solvents.
Keep away from heat sources and do not immerse in water or other
liquids.
In case of problems due to malfunctions, defects, unexpected
events or situations and for the maintenance procedures of the
device, please contact the manufacturer or the local distributor.
The device is for single person use.
Do not use the device when it is charging.