Operation; First Use; Daily Use - Zanussi ZBA3230A Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its refrig-
erant circuit or insulation materials. The appliance shall
not be discarded together with the urban refuse and

Operation

Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
Switching off
To turn off the appliance, turn the Temperature regu-
lator to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower set-
tings to obtain the minimum coldness.
• turn the Temperature regulator toward higher set-
tings to obtain the maximum coldness.

First use

Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.

Daily use

Movable shelves
The walls of the refriger-
ator are equipped with a
series of runners so that
the shelves can be posi-
tioned as desired.
rubbish. The insulation foam contains flammable
gases: the appliance shall be disposed according to the
applicable regulations to obtain from your local author-
ities. Avoid damaging the cooling unit, especially at the
rear near the heat exchanger. The materials used on
this appliance marked by the symbol
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping
in mind that the temperature inside the appliance de-
pends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or the
appliance is fully loaded, and the appliance is set to the
lowest temperatures, it may run continuously causing
frost to form on the rear wall. In this case the dial must
be set to a higher temperature to allow automatic
defrosting and therefore reduced energy consumption.
Important! Do not use detergents or abrasive pow-
ders, as these will damage the finish.
are recyclable.
35

Publicité

Table des Matières
loading

Table des Matières