Télécharger Imprimer la page

SpeedEPart Agri-Fab 45-02661 Notice D'installation page 5

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(2)
9/16" Wrenches
(2)
3/4" Wrenches
(2)
1-1/8" Wrenches or 10" Adjustable Wrenches
(1)
Grease Gun
CAUTION: Disc blades have sharp edges. Use
care in handling and assembly. Wear gloves for
extra protection against cuts.
Remove loose parts and hardware package from the
carton. Lay out and identify as shown on pages 2 and 3.
1. Assemble four discs to each bearing hanger bracket
using a bearing sleeve (unplated), a 3/4" x 16" hex
bolt, eight 3/4" flat washers, two spacers and two 3/4"
hex nuts. Be sure the discs face the same direction
relative to the hanger bracket as shown in the figure
1. Tighten the first hex nut and then tighten the
second hex nut against the first.
2. Lubricate the bearings through the grease fittings in
the bearing hanger bracket assemblies until grease is
forced out through the bearings.
BEARING HANGER
BRACKET
BEARING SLEEVE
SPACER
3/4" HEX NUTS
DISC BLADE
FIGURE 1
ENGLISH
3/4" FLAT WASHER
SPACER
3/4" x 16"
HEX BOLT
3. Assemble the hitch bracket to the draw bar using two
1/2" x 1-1/2" carriage bolts and 1/2" nylock nuts. See
figure 2.
DRAW BAR
1/2" NYLOCK NUT
HITCH BRACKET
FIGURE 2
4. Position the tray with the slots angled either toward
rear center or front center as shown in figure 3. (Refer
to Operation section on page 6 for more information.)
Assemble the drawbar to the bottom of the tray using
two 1/2" x 1-1/2" carriage bolts and 1/2" nylock nuts.
See figure 3.
THROWS SOIL
TO OUTSIDE
1/2" NYLOCK NUT
FIGURE 3
5
1/2" x 1-1/2"
CARRIAGE BOLT
1/2" x 1-1/2"
CARRIAGE BOLT
THROWS SOIL
TO INSIDE

Publicité

loading