Genesis GLSD72A Manuel D'utilisation page 4

• Avoid accidental starting.
Carrying power tool with your finger on the switch or plugging in power tools that have the switch
on invites accidents.
• Remove any adjusting keys or wrenches before turning the power
tool on.
injury.
• Do not overreach.
cause an injury in an unexpected situation
• If devices are provided for connection of dust extraction and
collection facilities, ensure these are connected and properly used.
use of these devices can reduce dust related hazards.
• Do not use a ladder or unstable support.
better control of the tool in unexpected situations.
• Keep tool handles dry, clean and free from oil and grease.
cannot safely control the tool.
TOOL USE AND CARE
Secure the work piece.
•
stable platform. Holding the work piece by hand or against your body is unstable and may lead to
loss of control.
• Do not force the power tool.
rate for which it is designed. forcing the tool could possibly damage the tool and may result in
personal injury.
• Use the correct power tool for the job.
job for which it is not designed.
• Do not use tool if switch does not turn it on or off.
controlled with the switch is dangerous and must be repaired or replaced by an authorized service
.
center
• Turn power tool off, and disconnect the plug
battery pack from the power tool before making any adjustments, changing the accessories, or
storing the tools
may cause personal injury
• Store idle tool out of reach of children and other inexperienced
persons.
• Maintain power tools with care.
parts, component breaks, and any other conditions that may affect the tool's operation. A guard
or any other part that is damaged must be properly repaired or replaced by an authorized service
center to avoid risk of personal injury.
• Use recommended accessories.
recommended by the manufacturer or intended for use on this type tool may cause damage to
the tool or result in personal injury to the user. Consult the operator's manual for recommended
accessories.
• Keep cutting tools sharp and clean.
cutting edges are less likely to bind and are easier to control
4
A wrench or key that is left attached to a rotating part of the tool may result in personal
Maintain proper footing and balance at all times. Loss of balance can
use clamp or other practical way to hold the work piece to a
.
Such preventive safety measures reduce the risk of an accidental start up which
.
It is dangerous in the hand of untrained users.
7.2V Lithium-ion Screwdriver
Operator's Manual
ensure the switch is in the off position before plugging in.
.
Stable footing on a solid surface enables
The tool will perform the job better and safer at the feed
Don't force the tool or attachment to do a
Check for proper alignment and binding of moving
using accessories and attachments not
Properly maintained cutting tools with sharp
Any tool that cannot be
from the power source and/or
.
GLSD72A
Slippery handles