Publicité
Les langues disponibles
Les langues disponibles
To change the unit settings:
1.
unscrew the two safety screws
2.
open the cover
3.
use button ENT, - and + to program unit
4.
for advanced settings connect a TPE into RJ45
Quick guide:
3.1 Press and hold +, - and ENTER buttons for around 5sec
to set DVB-T or DVB-C standards (Default DVB-T)
3.2 Select Coun and set your country for your TV standards
3.3 Select Ch and set your output digital channel
3.4 Select OutL and set the output level of your DVB-T channel
3.5 Select Lcn to set the logical channel number.
4.1 On-board configuration
Button Description
ENT
ENTER button to select the MENU and to confirm a value
–
To decrease a value or browse the menu upwards
+
To increase a value or browse the menu downwards
To exit the menu, do not press any button for 5 seconds.
On-board menu
Display
Menu and submenus description
Fr
Firmware version installed on the unit Hw.Sw
Country settings, to set correct TV standards and LCN advanced parameters
UK
United Kingdom
(ovn
Oc1
(Default UK)
(h
Output channel
LCN
Logical Channel Number
0VtL
Output Level
AVdL
Audio level
Ar
Aspect Ratio
SStr
Service Name
Sind
Service Index
ALC: Dynamic audio level adjustment.
Set LCN to 1000 to disable the LCN function.
4.2 Advanced configuration using a TPE
The TPE allows you to fully configure the unit such as the following parameters: advanced COFDM and QAM
parameters (Modulation, FEC, ..), TS advanced settings (i.e. LCN) and service name.
4. PROGRAMMING INSTRUCTIONS
EU
Oc2
Other country1
See Tab.1 (Default C21)
1÷1000 (Default 100)
OFF,60÷90dB (Default 90dB)
OFF,-6÷34dB,ALC (Default 0dB)
AUTO, 4:3, 16:9 (Default AUTO)
See par. 4.2.1 and Tab. 3 (Default 0=EXTSRC)
0÷99 (Default 0=Empty string)
Fr
Europe
France
Oc3
Other country 2
12
1
AV
Australia
Other country3
2
3
Publicité
