Fracarro MOD-DVB-TC Instructions D'emploi page 11

1. Plug the power cord to the unit mains connector and to the mains socket.
2. Connect the AV input in the RCA connectors
3. Connect the coaxial cable of distribution to OUT connector
Fig.1 standard connection More schematics are available at the end of this instruction manual.
DEFAULT SETTINGS AND SOFTWARE RESET
Input
Output
To change type of modulation (COFDM/QAM)
Press and hold +, – and ENTER buttons for around 5sec until the display shows the message DVB-T and
DVB-C. The unit must be switched ON and in operating mode (not in programming: display OFF and TPE
disconnected). ATTENTION: If display shows BOOT, restart the product.
To restore default settings
Press and hold + and – buttons for around 5sec until the display shows the message REST (RESET). The
unit must be switched ON and in operating mode (not in programming: display OFF and TPE disconnected).
ATTENTION: this procedure does not change the modulation standard (COFDM o QAM)
3. PRODUCT INSTALLATION
VIDEO
AUDIO
AUDIO BIANCO
Sampling rate
Audio Gain
Type
Brightness
Video Saturation
Hue (NTSC)
Country
Channel
Output Level
Aspect Ratio
COFDM parameters
LCN
Service Name
TS parameters for LCN
YELLOW GIALLO
ROSSO
RED
WHITE
Modul: 16QAM
Guard Int. : 1/32
UK (see Tab.2)
11
RF OUT
To TV distribution
Alla distribuzione TV
RF = 75
48KHz
0dB
Stereo
8
8
0
UK
C21
90dB
Auto
FEC: 1/2
100
EXTSRC