Components; Accessories; Location Identification Plate - Vermeiren 708D Mode D'emploi

The wheelchair complies to the requirements set up in:
ISO 7176-8: Requirements and test methods for static, impact and fatigue strengths.
EN 1021-1: Assessment of the ignitability of upholstered furniture - Ignition source
smouldering cigarette
EN 1021-2: Assessment of the ignitability of upholstered furniture - Ignition source match
flame equivalent
ISO 7176-19: Wheeled mobility devices for use as seats in motor vehicles.
1.3

Components

1.4

Accessories

The following accessories are available for the 708D:
Armrests (B02, B03, B05, B66)
Leg supports (B06, B07, B08, BZ7, BZ8, BZ9, BZ10, BK7, BL7, BA6, BK6)
Table (B12)
Crutch holder (B31)
Back (L14, L24, L44)
Anterior pelvic belt (B58) for mounting over the backrest tube
Anti-tipping device (B78) for mounting on the bottom back frame
Drum brakes for the attendant (B74) for mounting on the push handles
Transit wheelchair (T30)
Moving the axle back (AMP)
Quick release (B80)
Lowering seat height to 470 mm (S)
1.5

Location identification plate

1 = Cross
2 = Handles
3 = Back
4 = Arm pads
5 = Arm supports
6 = Driving wheels (rear wheels)
7 = Hand rims
8 = Brakes
9 = Tip cap
10 = Steering wheels (Front wheels)
11 = Seat
12 = Footrests
1 = Taxi hooks
2 = Identification plate
3 = Name 708D
Page 5
708D
2011-05