Selecting A Display Language; Registering The Handset For The First Time - Auerswald COMfortel M-530 Notice D'utilisation

Initial Commissioning
• Before you use the handset for the
first time, put it in the charging cradle
and fully charge the rechargeable
batteries.
The rechargeable batteries are fully
charged when the lighting flash
symbol goes out in the display.
Caution: The handset must be
charged in the charging cradle
supplied with it!
Note: The rechargeable batteries might warm up during charging. This is
not dangerous. For technical reasons, the charging capacity of the
rechargeable batteries reduces over time.

Selecting a Display Language

The language setting display is displayed. The set
language (e. g. English) is marked (
1. Press until the required language, e.g. Français,
is marked in the display.
2. Press the right-hand key directly under the display to activate the language.
3. Exiting the menu: Press
If you need to display the menu again, do this:
1. Press the middle of the control key
2. Slowly press

Registering the Handset for the First Time

These instructions describe how to register the telephone on a COMfortel WS-
500S or COMfortel WS-500M base station for the first time.
Requirements:
• The handset has been configured in the base station
• Registration has been triggered in the base station.
Note: You can configure the base station manually or by provisioning via
the PBX. Please refer to the base station Operation Guide for instructions.
Note: You can find out the handset's IPUI in the battery compartment and
on the packaging label or scan it in. Alternatively, you can view the IPUI
on the display. To do so, press the centre of the control key
28
for a long time.
and , one after the other.
COMfortel M-530 - Instructions V03 02/2020
Deutsch
= selected).
English
Français
.
7,5 h
to display