Wacom DTF-720 Guide D'installation Et Manuel D'utilisation page 43

The pen tip and screen
cursor do not properly line
up.
The screen cursor moves
but it does not jump to the
pen tip location when the
pen is placed on the display
screen, and it does not
follow the pen tip when the
pen is moved across the
display.
When using the pen display
tablet on a multiple monitor
system, you cannot use the
pen to control the other
monitor(s).
The line you are drawing
does not line up with the
location of the screen
cursor.
Open the Pen Tablet control panel and select the C
Continue with Calibrating the DTF-720 on page 22.
Make sure the Wacom tablet driver has loaded properly by opening
the Pen Tablet control panel. If the driver did not load you will see an
error message. If an error message appears, reboot your computer.
If the problem persists, refer to the Installation instructions and
reinstall the Wacom tablet software. (For Macintosh, you must restart
your computer after installing the Wacom tablet driver for proper
tablet operation.)
If you have customized the side switch on your pen to toggle between
pen mode and mouse mode, make sure that your pen display is
operating in pen mode. See Customizing the side switch button
functions, beginning on page 24.
You can use your pen to control the other monitors in mouse mode.
To use mouse mode, first set the pen's DuoSwitch to M
T .... Then use the switch to toggle between pen mode and
OGGLE
mouse mode.
To function properly, some applications require that the pen is set to
pen mode. Make sure the pen has not been toggled to mouse mode.
If the pen is set to pen mode and the problem still exists, then you
may have a corrupted preferences file. Follow the instructions in the
next tip to create a new preferences file.
tab.
ALIBRATE
ODE
Troubleshooting
Page 39