Haussmann PG2200-3 Manuel De L'utilisateur page 31

OPERATING INSTRUCTIONS
in hand injuries. Wear protective gloves
when starting the equipment.
Connecting tools to the generator
Connect the equipment you want to use to
the socket-outlets (3/4)
IMPORTANT!
- These sockets may be loaded
continuously (in S1 mode) and temporarily
(in S2 mode).
- Do not connect the generator to the
domestic power network as this may result
in damage to the generator itself or to other
electrical appliances in your home.
Note: Some electrical appliances (power
jigsaws, drills, etc.) may have a higher level
of power consumption when used in difficult
conditions.
Switching off the engine
- Before you switch off the generator, allow
it to run briefly with no consumers so that it
can "cool down".
- Move the ON/OFF switch (12) to position
"O".
- Close the oil cock.
Overload cut-out for socket-outlets
Important! The generator is fitted with an
overload cut-out.
This shuts down the sockets (3/4). You can
restart the sockets (3/4) by pressing the
overload cut-out (7).
EN
IMPORTANT!If this happens, reduce
the electric power you are taking from
the generator or remove any defective
connected appliances.
IMPORTANT! Defective overload cut-outs
must be replaced only by overload cut-
outs of identical design and with the same
performance data. If repairs are necessary,
please contact your customer service
centre.
31