Operating Instructions; Before Putting The Machine Into Operation - Haussmann PG2200-3 Manuel De L'utilisateur

OPERATING INSTRUCTIONS

Before putting the machine into
operation
Wheel assembly (fig. 3-4)
1. First place one end of the bolt (item 19)
through the hole in the frame and secure it
with a nut and washer.
2. Put the socket through the other end of
bolt (item 19) and place the wheel, washer
and secure it with the nut.
3. Place the wheel cover and secure it with
a clip as illustrated on the inner cover.
4. Repeat above steps for the left side.
IMPORTANT!
The inner wheel should be inflated for it has
been shipped out with lower pressure (max.
gauge pressure 3 bar/0.3 MPa).
Rubber feet assembly (fig. 5)
Hold the foot (item 15) against the frame
as shown. First place the bolt through the
hole in the frame and the hole in the foot
and secure it with a nut. Then secure other
three bolts and nuts with same procedure.
Transport handle assembly (fig. 6-7)
Place the carry handle (item 18) through
the bracket and tighten it with knob (item
18). Then place the bolt with a gasket
through the hole in the frame and the push
bar. Secure with a washer and a nut, as
shown in Figure (6-7).
Electrical safety
EN
- Electric supply cables and connected
equipment must be in perfect condition.
- The generator is to be operated only with
equipment whose voltage specifications
corresponding to the generator's output
voltage.
- Never connect the generator to the power
supply (socket-outlet).
- Keep the cable length to the power tool as
short as possible.
Environmental protection
- Dispose of soiled maintenance material
and operating materials at the appropriate
collection point.
- Recycle packaging material, metal and
plastics.
Grounding
The housing is designed to be grounded,
in order to discharge static electricity. To
do this, connect one end of a cable to the
grounding connection (6) on the generator
and the other end to an external grounding
device (for example an grounding rod).
Operation
IMPORTANT!
You must fill generator up with engine oil
and fuel before you can start the engine.
- Check the fuel level and top it up if
necessary.
- Make sure that the generator has
sufficient ventilation.
- Make sure that the ignition cable is
secured to the spark plug.
- Inspect the immediate vicinity of the
generator.
- Disconnect any electrical equipment that
may already be connected to the generator.
Starting the engine
- Do not connect the power tool before
starting the motor.
- Open the oil cock (12) by turn to position I.
- Move the ON/OFF switch (9) to position
"I".
- Move the choke lever (10) to position IØI.
- Start the engine with the pull cord (11) by
pulling the handle forcefully. If the engine
does not start, pull the handle again.
- Push the choke lever (10) back again after
the engine has started.
IMPORTANT!
When starting with the pull cord, the motor
may recoil suddenly as it starts up, resulting
30