Jotul F 480 Série Manuel D'installation page 8

ENGLISH
Fig. 9
6. Loosen the height adjustment screws slightly
the product so that they can be screwed by hand. NB: If the
optional glass oor plate is to be installed, the base must
be raised approximately 8 mm off the oor so that it can be
pushed under the front edge of the base.
7. Carefully remove the wooden pallet.
8. Place a packaging frame (A) crosswise underneath the
base/pedestal/leg and cardboard packaging in front of/
beneath the product to prevent it from making marks on
the oor. Carefully raise the stove and stand it in its proper
place ( g 1). Remember to position it straight above or
behind the external air supply, whichever is applicable.
9. Place the top plate ( g. 3 A) temporarily in place and
level the replace. If the stove is not standing level, adjust
the screws shown in g. 9 A until the product is perfectly
straight.
10. If the control handles
8
beneath
are dif cult to pull out, see
4.9 Location of approval label
g. 11.
Fig. 11, Base
Fig. 11, Pedestal