shark NV351 Guide Du Propriétaire page 13

Cord
Hook
a
b
c
Fig. 11
TO USE:
1
Rotate the cord release to quickly release the
power cord.
2 Secure the power cord in the cord hook (a).
(Fig. 11)
= Brush Roll ON
= Bare Floor
= OFF
3
Press the On/Off switch (b) to the "I" position to
vacuum bare floors (straight suction only) or to the
"II" position to engage the motorized floor brush (for
vacuuming carpets and rugs). (Fig. 11)
IMPORTANT: The motorized brush indicator light
(c) will illuminate green when motorized floor brush
is on, or red if there is a blockage or jam. (Fig. 11)
This feature is designed to protect your Lifetime
Belt that powers your motorized floor brush. See
Checking for Blockages on page 19.
Suction
Release Collar
Release suction
for easier push &
pull on high pile
d
carpets and area
rugs.
Fig. 12
4
Gently press the floor nozzle down with your
foot while you grasp the handle and tilt it back
towards you. (Fig. 12)
NOTE: The rotating brush on the motorized floor
brush will not spin unless the nozzle is flat against
the floor and the handle is tilted back.
5
Due to the huge suction power of this
vacuum, it may become necessary at
times to adjust the suction release (d) on
the handle. (Fig. 11) If the vacuum seems
difficult to push or pull or if it is lifting up
area rugs, adjust the suction release by
rotating the collar 90° counterclockwise to
open the valve. Rotate the collar clockwise
to close the valve when you need high
suction and for vacuuming floors.
6
Empty dust cup after vacuuming and periodically
during use when it appears full. (See "Maintenance"
section for instructions.)
7
When you are finished vacuuming, turn the
vacuum off.
www.sharkclean.com 13