Settings; Before First Use; Daily Use - Zanussi ZTE7100PZ Notice D'utilisation

Settings

A B
A) Delicate button
B) Textile button: Cotton
C) Start/Pause button

Before First Use

Before you use the appliance for the first time
do these operations:
• Clean the tumble dryer drum with a moist
cloth.

Daily Use

Start a programme
1. Prepare the laundry and load the appliance.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance
door and the rubber seal.
2. Set the correct programme and options for
the type of load.
3. Press the Start/Pause touchpad.
The programme starts.
Change a programme
1. Turn the Programme knob to
2. Set the programme.
At the end of the programme
When the programme is completed:
• An intermittent acoustic signal operates (If
the Buzzer function is on).
• The indicators
Filter comes on.
• The Start/Pause indicator is on.
22
C
, Synthetic
OFF
End/Anticrease and
Buzzer on/off
To deactivate or activate the acoustic signals,
press and hold for approximately 2 seconds
touchpads (A) and (B) at the same time.
• Start a short programme (e.g. 30 minutes)
with moist laundry.
The appliance continues to operate with the
crease guard phase for approximately other 30
minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when
the phase is almost completed or completed.
When the crease guard phase is completed:
• Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter when a
programme is completed.
Stand-by function
To decrease the energy consumption, this
function automatically deactivates the
appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme.
OFF
www.zanussi.com