Ipod/Iphone Operation - Audiovox VME 9725 NAV Mode D'emploi

Récepteur multimédia mobile
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

iPod/iPhone OPERATION

NOTE: Be sure your iPod has the latest Apple firmware installed to avoid
connectivity issues.
Accessing iPod Mode
This unit is Made for iPod and iPhone. You can control your iPod via touch screen
to access Playlist, Artist, Albums, Songs, etc. Supported models include, but are not
limited to the following:
• iPhone 4S / 4 / 3GS /
• iPodtouch 5th and 4th Generation
• iPod nano 6th and 5th Generation
• iPod classic
The unit will automatically switch to iPod mode when an iPod, iPod touch or iPhone is
plugged into the front
or rear
USB connector.
NOTE: For basic iPod connectivity, you can use the white 30-pin to USB iPod
cable that came with your Apple device . For iPod video or photo playback, you
must use the Audiovox jLink4 cable.
To return to the iPod menu from any other source menu, touch SRC on the front panel
until the iPod menu appears on the screen, or choose the iPod icon from the source
menu (only available when an iPod or iPhone is connected to the USB connector).
NOTE: To transmit the video from your iPod to the VME 9725 NAV screen, you
must set the following options through the iPod video settings menu:
TV Out = On, TV Signal = NTSC, and Widescreen = On.
NOTE: After disconnecting your iPod, the VME 9725 NAV will always return to
the last mode accessed.
126

Publicité

Table des Matières
loading

Table des Matières