KRESS AMT 132 Mode D'emploi page 11

AMT 132 - Buch Seite 11 Dienstag, 23. Mai 2000 9:14 09
AMT 132
Recommended number of strokes
Low range for treating glass, ceramics and
metal, and also for sawing using the
tenon saw blade.
Medium range for treating plastics, pressed material
and plywood.
High range for treating hard wood, soft wood and
chip board.
Adjusting the Pendulum Stroke Setting
The pendulum stroke settings "0" and "1" are
selected using the pendulum stroke switch 3.
In position "0" the pendulum stroke is switched off.
Recommended Pendulum Stroke Setting
Position "0" for glass, ceramics, soft steel,
non-ferrous metal, aluminium and
pressed material.
Position "1" for plastics, plywood, hard wood,
soft wood and chip board.
9 Practical Tips
The tool holder is designed for using different tools
such as a sander, knife of brushes. The pendulum
stroke must be switched off for these applications.
For sawing, the pendulum movement must be
switched off. As soon as a cutting depth of approx.
2 – 3 mm is reached, the pendulum action can be
switched on to achieve an optimum cutting perform-
ance.
When using a saw blade, make sure that the material
to be sawn is pressed against the saw stop plate 2.
This pressure is additionally supported by the move-
ment of the saw blade 1.
Should the saw blade jam, switch the machine off
immediately, wedge the sawing slit open using a suit-
able tool and carefully pull out the machine together
with the saw blade.
When sawing metals the pendulum action must be
switched off and a little oil should be applied to the cut-
ting spot. Sheet metal should be clamped to a firm
surface (chip board or plywood) in order to prevent the
material from swinging with the sawing action as far
as possible.
Danger of kick-back: When the sawing procedure is
finished, switch the machine off and do not pull the
saw blade out of the cut until it has come to a stand-
still.
10 Maintenance Measures
Before any work on the machine itself, remove the
battery.
Always keep the ventilation slots clean.
Wipe off the accessible plastic parts regularly with a
cloth without cleaning agent.
From time to time, a drop of oil should be applied to
the moveable roller guide for the tool.
Servicing Instructions
If you make heavy use of the equipment for an
extended period of time, we recommend returning it
together with the charger to our servicing department
for a thorough inspection at regular intervals. This pre-
vents high repair costs and extends the service life of
your equipment.
11 Environmental Protection
Kress takes back worn-out machines
for the purpose of resource-saving
recycling. As a result of their modular
construction, Kress machines can be
very easily dismantled into their reusa-
ble materials.
Akku
Recycling
Do not open battery and dispose of it through the
available collection points.
Do not place the battery on any heated surface or
expose it to strong sunlight for a longer period of time.
Do not expose the battery to temperatures over 50 °C.
Give your worn-out Kress machine to your dealer or
send it directly to Kress.
Subject to change without notice
English
11
Defective
rechargeable
batteries must
be recycled
according to the
Guidelines
91/157/EEC.
Do not throw
used batteries in
household waste,
in fire or in water.