SPIKES-SPIDER ALPINE Instructions De Service page 10

Mounting
1
5
english
2
1
Remove the hub cover. Put the box wrench into the center of the hub cover and turn the tor-
que handle (metal bar) under slight pressure to the left.
2 Spread the synthetic bows and make sure that the half circled slit in the circular holding device
of the SPIKES-SPIDER is positioned to the bottom / the road.
3 Push the bows with the chain of the SPIKES-SPIDER first over top, then on the left side and then
on the right side of your tire, while pressing the holding device as close to your rim as possible.
4
Put on the locking disc, press it against the adapter plate and turn it to the right or left, until
the red security bar "clicks" in completely.
The lower part of the chain, which is aside to your tire now, will mount itself while
starting to roll.
5
Please check the size adjustment before you continue to drive. A flat hand must fit between your
tire and the chain. Size adjustment is easy to do with the SPIKES-SPIDER (ref. to Adjustments).
3 4