Publicité
Les langues disponibles
Les langues disponibles
► 1 . Rear cover
2.
Slide the built-in battery halfway. Disconnect the
lead wires from the battery by slightly moving back the
battery while pressing the connector in the direction of
arrow shown in the figure.
1
► 1 . Connector 2. Lead wires
3.
Then slide the battery unit completely.
Troubleshooting
Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
CAUTION:
Do not attempt to repair the cleaner by yourself.
1
2
Area to be investigated
Is the capsule full of dust?
Is the filter clogged?
Is the battery cartridge exhausted ?
Is the battery cartridge exhausted ?
12 ENGLISH
► 1 . Battery unit
4.
Put the removed battery unit in a carton box so
that it is not circuit-shorted.
Installing replacement battery
To install the replacement battery, follow the removal
procedure in reverse.
CAUTION:
Route the lead so that it is com-
pletely stored inside the cleaner before putting
the rear cover back in the original position. Failure
to do this may damage the lead.
After installing the battery (see "SPECIFICATIONS"),
charge the battery before use.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Empty the capsule of dust.
Clean or wash the filter.
Charge the battery cartridge.
Charge the battery cartridge.
1
Fixing method
Publicité
