Publicité
Les langues disponibles
Les langues disponibles
Slip the main post (21) over the boss
(101) on the main body in the direction
of the arrow, Fig.6, making sure not to
snag any of the cables.
Fit the screws (9), along with the
washers
(13)
previously, Fig.6, and tighten securely.
Lower the bottom trim section (22) for
the main post (21) down over the boss
section of the main body (101), Fig.6.
Fit the bottom cover (54).
5. FITTING THE FOCUS
BARS.-
Insert the focus bar spindle (108)
through the spacer bushes on the
main post (21), Fig.7, leaving it
centred.
Fit the spacer washers (17) as shown
in Fig.7. Insert the left focus bar (15L)
(marked with the letter "L") onto the
focus bar spindle (108), Fig.7, then fit
the right focus bar (15R) (marked with
the letter "R") on the other end of the
spindle. Fit the bolts (14) and the flat
washers (12-13) and with the help of
the box spanners tighten securely.
6. FITTING THE FEET.-
Take the right pedal (45), Fig.8,
(marked with the setter "R") and slide
it onto the crank shaft (73) on the
right- hand side of the machine.
Now take washer (13) (52) and bolt
(14) and tighten securely.
Take the left pedal (45), Fig.8,
(marked with the setter "L") and slide it
onto the shaft (73) on the left-hand
side of the machine.
Now take washer (13) (52) and bolt
(14) and tighten securely.
Attach the bottom covers (51), Fig.8,
and fit screws (85).
and
(10),
removed
7. FITTING THE FOOT BARS.-
Take the right foot bar (45) and
position it on the "U" at the bottom of
the right focus bar (15R), Fig.9.
Insert screw (46), as shown in Fig.9,
then fit the flat washer (44) and the
self locking nut (43), and tighten
securely.
Take the left foot bar (15L) and go
through the same assembly procedure
as with the right.
8. FITTING THE FOCUS BAR
SIDE COVERS TO THE FOOT
BARS.-
Next fit the footrest covers (42R) and
(42L) with the bottom of the joints on
the right side, Fig.10. Use screws (41)
to screw them together. Then do the
same with the other covers on the left-
hand side.
9. FITTING THE UPPER
FOCUS BARS.-
Take hold of the Hand-grip connectors
(2), sticking out of the top bars (7L)
and (7R).
Take the top left bar (7L) (marked with
the letter "L").
Insert the top bar onto the bottom left
focus bar (15L), lining up the letters
(L), Fig.11, fit the screws (9), the
washers
(10)
securely. Now go through the same
procedure for the top right focus bar
(7R).
10. FITTING THE FOOTRESTS.-
Next, remove the screws (48), the flat
washers (89) (91) and the knobs (90)
and position the right footrest (47R)
(marked with the letter "R") on top of
the unit's right foot (45), Fig.12, (left
and right refers to the user's position
17
(13)
and
tighten
Publicité
