Philips 9000 Série Mode D'emploi page 36

ENGLISH
36
Problem
The shaver does
not work when I
press the on/off
button.
The shaver does
not shave as
well as it used
to.
Guarantee restrictions
The shaving heads (cutters and guards) are not
covered by the terms of the international guarantee
because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems
you could encounter with the appliance. If you are
unable to solve the problem with the information
below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer
Care Centre in your country.
Possible cause
The shaver it still
attached to the
mains. For safety
reasons, the shaver
can only be used
cordlessly.
The rechargeable
battery is empty.
The travel lock
is activated.
The shaving heads
are damaged or
worn.
Solution
Unplug the shaver and press
the on/off button to switch
on the shaver.
Recharge the battery
(see chapter 'Charging').
Press the on/off button for
3 seconds to deactivate the
travel lock.
Replace the shaving heads
(see chapter 'Replacement').