Philips 9000 Série Mode D'emploi page 14

ENGLISH
14
- Only use the SmartClean system with the original
cleaning cartridge.
- Always place the SmartClean system on a stable,
level and horizontal surface to prevent leakage.
- Always make sure that the cartridge compartment
is closed before you use the SmartClean system
to clean or charge the shaver.
- When the SmartClean system is ready for use,
do not move it to prevent leakage of cleaning fluid.
- The SmartClean system thoroughly cleans but
does not disinfect your shaver, therefore do not
share the shaver with others.
- Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as petrol
or acetone to clean the appliance.
- Water may leak from the socket at the bottom
of the shaver when you rinse it. This is normal
and not dangerous because all electronics are
enclosed in a sealed power unit inside the shaver.
Compliance with standards
- This shaver is waterproof and complies with the
internationally approved safety regulations. It is
suitable for use in the bath or shower and for
cleaning under the tap. For safety reasons, the
shaver can therefore only be used cordlessly.
- The shaver and the SmartClean system comply
with all applicable standards and regulations
regarding exposure to electromagnetic fields.
General
- The adapter is equipped with an automatic
voltage selector and is suitable for mains voltages
ranging from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.
- Maximum noise level: Lc = 69dB(A)