Philips 9000 Série Mode D'emploi page 30

ENGLISH
30
4 Clean the cutter and guard under the tap.
5 After cleaning, place the cutter back into the
guard.
6 Put the shaving heads back into the shaving
head holder.
Note: Make sure the notches on both sides of the
shaving heads fit exactly onto the projections in the
shaving-head holder.
7 Place the retaining ring holder on the retaining
ring (1), place it on the shaving head (2) and
turn it clockwise (3) to reattach the retaining
ring.
Repeat this process for the other retaining rings.
Note: Hold the shaving head holder in your hand
when you reinsert the shaving heads and reattach the
retaining rings. Do not place the shaving head holder
on a surface when you do this, as this may cause
damage.
8 Reattach the shaving head holder to the
bottom part of the shaving unit.