Publicité
Les langues disponibles
Les langues disponibles
User manual
2. Programming the remote control (calibrate/par)
Step 1
In order to pair the remote control to the system, remove the fuse (15Amp.) out of the
cable assembly from the hydraulic levelsystem or disconnect the 9 pin cable connector
from the operating system
connector).
REMARK: When using a 24V system, remove the 6 pin cable connector from the
operating system.
Step 2
Press the buttons
simultaneously.
When done, the Indicator LED (no.14) with the surrounding 4 arrows starts blinking
GREEN/ORANGE rapidly. This means the remote control is looking for its receiver,
mounted within the operating system.
Step 3
Depending on what action you performed under step1, reconnect the 9 pin connector,
the 6 pin connector or the fuse to the system.
- The pairing process should be made within a certain time
- The remote control turns off automatically.
- When the Indicator LED (no.14) goes off, the pairing process is complete.
Putting the remote control into use
After programming the remote control you now have the possibility to operate the levelsystem with the
remote control.
Step 1
Switch the remote control ON by pressing button
1 second.
Now the GREEN LED will light up by flashing. As long as you see this LED flashing,
the remote control is searching for contact with the operating system. When contact is
made the flashing stops.
The illumination of one or two ORANGE arrows on the indicator LED (no.14) central on
the control panel shows the position of the vehicle.
In the unlikely event that the vehicle is already level, then the indicator LED (no.14)
lights up GREEN.
Further operation goes as described in the E&P Hydraulics Motorhome User manual
8
(do this by gently pressing the two hooks on the side of the
"AUTOMATIC MODE"
(no.7) and
"RETRACT ALL JACKS"
(apr. 20 sec.)
"ON / OFF"
(no.5) for at least
E&P HYDRAULICS
(no.8)
Publicité
