Publicité
Les langues disponibles
Les langues disponibles
CONNECTION OF THE OUTDOOR SENSOR WITH THE WEATHER STATION
The outdoor sensor connects automatically after 1 minute. Otherwise, you can connect the devices
manually:
- Press button (20) for 3 seconds.
- When the weather station detects the sensor, the outdoor temperature will be displayed (13).
- The sensor data is sent automatically about every 3 minutes.
2 - SETTING THE TIME AND DATE
- Press button (16) for 3 seconds to enter the time and date setting mode.
- Use buttons (21) and (22) to adjust the values. Hold the buttons down to speed up scrolling.
- The day of the week is displayed automatically (6).
- If the buttons are not pressed, the unit returns to the normal display after 15 seconds.
3 - SETTING THE ALARM
SETTING AND ACTIVATING THE ALARM
- Press button (17). The symbol «AL1» appears on the screen.
- Use buttons (21) and (22) to set the alarm hour. Press button (17) to confirm. The minute digit
flashes.
- Use buttons (21) and (22) to set the alarm minutes. Press button (17) to confirm.
- Select the alarm mode (Beep/Radio/USB) using buttons (21) and (22)
● Beep alarm: the symbol «bP» appears on the screen.
● Radio alarm: the frequency is displayed on the screen. The alarm will activate the last station
listened to.
● The USB symbol appears on the screen. This wake-up mode is only valid if a USB device has
been inserted into the USB port (28).
- The «AL2» symbol appears on the screen and flashes.
- Proceed in the same way as for alarm 1.
- To select one of the two alarms, press button (17) in standby mode (screen with time display). The
screen will display consecutively the symbols «AL1», «AL2» then the 2.
- Press button (17) again to deactivate the alarms (no symbol is displayed).
SWITCHING OFF THE ALARM
The alarm will go off at the programmed time. To stop the alarm, press button (16). It will sound again
the next day at the same time.
SNOOZE FUNCTION
- When the alarm sounds, press button (18): the symbol flashes.
- The alarm will sound again after 9 minutes.
- The snooze function is active as long as the symbol flashes on the display.
- To cancel the snooze function, press button (18).
Publicité
