Fonctionnement De Votre Cycle Exerciseur Pliant; Console Du Modèle Fb360 - XTERRA Fitness FB 360 Guide D'utilisation

FONCTIONNEMENT DE VOTRE CYCE EXERCISEUR PLIANT
FAMILIARISEZ-VOUS AVEC LE TABLEAU DE COMMANDE
CONSOLE DU MODÈLE FB360
BOUTONS DES FONCTIONS
BOUTON FONCTIONNEL :
MODE – Push down to select functions.
SET - To Set the consumer movement of time, distance, calories and hand pulse.
RESET -For resetting consumer movement of time, distance, calories and hand pulse.
FONCTIONS ET OPÉRATIONS
1. SCAN: Press the MODE button until SCAN appears, the monitor will rotate through the 6 functions: time,
speed, distance, calorie, odometer, and pulse. Each display will be held 6 seconds.
2. TIME: Shows your elapsed workout time. Press the MODE button until "TIME" appears, press SET button to set
target time. When the target time is reached, the console will beep for 10 seconds.
3. SPEED: Display current speed.
4. DISTANCE: Count the distance from exercise start to end. The maximum value is 999.99miles. Press the MODE
button until "DISTANCE" appears, press SET button to set target distance. When the target distance is reached,
the console will beep for 10 seconds.
5. CALORIE: Count the total calories from exercise start to end. Press the MODE button until "CALORIE" appears,
press SET button to set target calories. When the caloric goal is reached, the console will beep for 10 seconds.
6. ODOMETER：Monitor will display the total accumulated distance.
7. PULSE RATE: Press the MODE button until "PULSE" appears. Press SET button to set target heart rate. The
heart rate range can be set anywhere from 40 - 240 BPM. When the target heart rate reached, the console will
beep.
Before measuring your pulse rate, please place your palms of the hands on both of the contact pads. The
monitor will show your current heart rate in beats per minute(BPM) on the LCD after 6~7 seconds.
During the process of pulse measurement, the measurement value may be higher than the actual pulse rate
during the first 2~3 seconds of reading, after which it will stabilize and display a more accurate reading. The
heart rate measurement value is not intended to be and should not be used as the basis for medical treatment.
NOTE：
1. If the display is faint or shows no figures, please replace the batteries.
2. The monitor will automatically shut off if there is no signal received after 4 minutes.
Dyaco Canada Inc 2019
14
customerservice@dyaco.ca