Whirlpool Gladiator Garageworks GATC5210WG Instructions D'assemblage page 3

Maximum weight limit is 75 lbs (34.0 kg) for the 47" (119.4 cm)
wide drawer.
Maximum weight limit is 50 lbs (22.7 kg) for each 22.2" (56.4 cm)
wide drawers.
The top of the cabinet can hold up to 100 lbs (45.36 kg) of evenly
distributed materials, or the Gladiator
Tool Chest with a load weight of 500 lbs (227.3 kg).
®
The Gladiator Garageworks Premier 10 Drawer - 52" Roll-Away
is designed to support a Gladiator
Chest stacked on top, as shown on the cover.
Remove the tools from the drawers before stacking and
unstacking, and use 2 or more people to lift the tool chest.
While using the tool chests, open only one drawer at a time
to avoid tipping.
Before moving the Roll-Away cabinet or Roll-Away cabinet
stacked with a tool chest to a different location, make sure all
the drawers are closed and locked. Use the push handle to
move the Roll-Away cabinet.
Unpack the Cabinet
NOTE: Keep the packing materials to cushion the cabinet during
assembly and then dispose of/recycle all packaging materials.
1. Remove the cabinet, parts and fasteners.
2. Verify contents. See "Parts Supplied."
Install the Bumpers
NOTE: Two of the bumpers are designed to match the contour of the
front of the cabinet, and two bumpers are designed to match the
contour of the back of the cabinet.
1. Using 6 mm hex-head bolts and washers, fasten a matching
bumper to each corner of the cabinet.
2. Completely tighten all the fasteners.
NOTE: To keep from stripping the bolts, do not overtighten.
A
B
A. Back bumper
B. Front bumper
Install the Push Handle
IMPORTANT: Install the push handle to the cabinet so that the
handle is on the same side as the swivel casters.
1. Insert the brackets on each end of the push handle into the slots
on the cabinet side.
2. Align the holes in the cabinet side with the holes in the brackets.
®
Premier 10 Drawer - 52"
®
Premier 10 Drawer - 52" Tool
C. Washer
D. Hex-head bolt
3. Using four 10 mm hex-head bolts and washers, fasten the handle
brackets to the cabinet.
B
A
C
D
A. Push handle
B. Handle bracket
C. Slot
Complete the Installation
1. Unroll the drawer liners and place a liner in each of the drawers.
2. Place the pad or wooden top on the top of the cabinet.
Use, Remove and Replace the Drawers
NOTES:
The key locks the roll-away cabinet and all of the drawers.
Use the drawer liners to avoid scratching or damaging the
drawer finish.
Removing the Drawer
1. Unload the contents from the drawer.
2. Slide out the drawer as far as it will go.
3. Press the lever down on the right-hand track and lift the lever up
on the left track to release the drawer. Pull the drawer out the rest
of the way.
B
C
D
Replacing the Drawer
1. Align the drawer guides with the receiving glides.
2. Hold the receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first time
after it has been removed.
3. Push the drawer in completely.
E
D. 10 mm hex-head bolt
E. Washer
A
A. Lever
3