Dirt Devil BLADE 2 MAX Mode D'emploi page 14

14
much charge is remaining. When less than 20%
charge is remaining the bottom light will flash
red indicating the battery is running low and
charging is required (Fig. 7 /3).
Using the stick vac
WARNING: The brushbar in the
!
powered head constantly rotates
when switched on. Never use the powered
head on one spot for an extended period
of time as the brushbar may damage the
floor surface. Always turn the powered head
brushbar off when cleaning hard floors. To
prevent any damage being sustained, test on
an inconspicuous area of the flooring first.
CAUTION: If the brushbar in the
powered head has been obstructed,
the brushbar motor protection sensor may
have been activated. The brushbar will stop
and the light on the powered head will
illuminate red (Fig. 18 ). To reset switch
the brushbar and stick vac off, remove the
powered head from the reach wand/handheld
and clear any obstruction. Wait 1 minute
before refitting the powered head tool, switch
the stick vac on and press the brushbar ON/
OFF button.
1. Place your foot on the powered head
(Fig. 8 /1) and pull the handle backwards to
recline (Fig. 8 /2).
2. To switch the stick vac on, press the ON/OFF
button located on the handle. (Fig. 9 /1) The On/
Off button and battery level indicator lights on
the handle will illuminate (Fig. 7 /2).
3. To increase suction for particularly dirty areas
that require additional cleaning boost mode can
be activated (Fig. 9 /3).
4. To switch the brushbar on, press the brushbar
ON/OFF button (Fig. 9 /2). The light on the
powered head and the brushbar ON/OFF light
will illuminate when the brushbar is on and the
brushbar will constantly spin. Press the brushbar
ON/OFF button again to turn the brushbar off.
NOTE: The powered head brushbar should
be ON for carpets and OFF for hard floors.
Constant use of the boost mode and brushbar
will reduce the battery run time.
5. All of the accessories, including the powered
head can be attached directly onto the handheld
(Fig. 10 ) or the reach wand. The crevice tool and
dusting brush can be used for hard to reach places
and at different heights for above floor cleaning.
MAINTAINING THE STICK VAC
WARNING: Always switch off the stick
!
vac and unplug from the charger and
mains before carrying out any maintenance
or troubleshooting.
Removing and refitting the dirt container
1. Push down the latch on the dirt container (Fig.
11/1 ) to release, tilt and lift to remove the dirt
container from the stick vac (Fig. 11/2 ).
NOTE: Before refitting, if the lid of the
container with separator has been removed
for cleaning make sure the separator has been
refitted and the lid has been locked into place
(Fig. 13/1 ).
2. To refit, line up the dirt container connection
with the stick vac handle. (Fig. 12/1) Press the
dirt container release latch (Fig. 12/2) and push
the dirt container onto the stick vac.