HAGER WERKEN SPEED LABOLIGHT Mode D'emploi page 11

Polymerization times for SOLIDEX:
In order to achieve a hardening time meeting the requirements of the material, the object to be poly-
merized on the 40 mm special rings has to be placed on the small object carrier in the center of the
turntable. For combination works with plaster models, please verify that polymerization carried out
from all sides and that the 6 cm inner radius of the rotary disc is not exceeded.
Material
SHOFU Solidex „Opaque Paste"
SHOFU Solidex „Base Paste"
SHOFU Solidex „Cervical Paste"
SHOFU Solidex „Body Paste"
SHOFU Solidex „Enamel Paste"
SHOFU Solidex „Translucent Paste"
SHOFU Solidex „Effect Paste"
SHOFU Solidex „Stains"
SHOFU Solidex „Stain color"
SHOFU Solidex „Endpolymerisation"
Polymerization times for LICUPLAST:
In order to achieve a hardening time meeting the requirements of the material, the object to be poly-
merized on the 40 mm special rings has to be placed on the small object carrier in the center of the
turntable.
Material
LICUPLAST Opaker
LICUPLAST Basic Masses
LICUPLAST Cervical Masses
Interim Polymerization (Fixing)
Tempering (Final Polymerization)
LICUPLAST dentine, transpa and
gingival masses
Interim Polymerization (Fixing)
Tempering (Final Polymerization)
LICUPLAST Stain Colors
NOTE! When working with SOLIDEX and LICUPLAST, the SPEED LABOLIGHT has to be
equipped with 8 Oxram Dulux S 9W/71 lamps (or Philips PLS – 9 W/52)) and 1 Osram HLX
15V/150W lamp.
Thickness of Layer (mm) Speed Labolight (min.)
≤ 0,15
≤ 2
≤ 1
≤ 2
≤ 2
≤ 2
≤ 2
≤ 0,15
Thickness of Layer (mm) Speed Labolight (min.)
≤ 0,2
up to max. 5,0
up to max. 1
> 2
up to max. 2
up to max. 1,5
> 2,5
up to max. 2,5
≤ 0,2
approx. 8 - 10
approx. 3
approx. 3
approx. 3
approx. 3
approx. 3
approx. 3
approx. 3
approx. 7
approx. 8 - 10
approx. 5
approx. 5
approx. 3
approx. 5
approx. 5
approx. 3
approx. 5
approx. 1
approx. 1
11