CBX LEOTIE Guide Utilisateur page 7

Take the frame out of the box. Release the fold lock a and open the frame, lifting upwards by
1
holding the handlebar. When you hear a clicking noise, the frame is assembled.
Take the front wheels out of the box. Place the wheel axle b into the fitting. The assembly is
2
complete when you hear a clicking noise.
3
In order to release the wheel, press the quick release button c and take the wheel off.
Assembling the rear wheels: fit the rear wheels by pushing the wheel shafts into the fitting in the
4
direction of the arrow. The clicking sound indicates that the assembly is complete.
5
To release, pull the button d upwards and pull the wheel out in the direction of the arrow.
6
To lock the rear wheels, press the lower part of the brake pedal e down.
7
To unlock, press the upper part of the pedal e.
Front wheels must be locked when in use on uneven ground. You can do so by using the wheel
8
lock button.
9
For maximum manoeuvrability in the city, the wheels can swivel.
Before folding the buggy, make sure the seatunit is in a sitting position with the backrest in up-
10
right position. Then press the fold button to fold the buggy.
The adapter for branded carseats (Cybex Silver Aton, CBX Aton, Maxi-Cosi Cabrio Fix) marked with
11
„R" is placed on the right side of the frame, the adapter marked with „L" is placed on the left side.
You should hear a „click" noise when installed correctly. Check that the adapter has been attached
properly before you put the carseat on top.
If using car seat 0+ Shima you do not need the adapter from frame.
Important — Keep these instructions for future reference.
Compatible with PURE, LUX, FLEX, Carrycot, CYBEX Aton Silver, ATON & Maxi Cosi Cabrio Fix (using
Adapter), SHIMA for BIMISI.
Warnings, safety instructions, maintenance, disposal and guarantee can be found in the warnings
booklet.
INSTRUCTIONS
EN
7