Hatco Glo-Ray GR2SD Série Manuel D'installation Et D'utilisation page 17

English
Left Mounting
Bracket
Center Mounting
Flip-Up Door Mounting Brackets
NOTE: For units 48" and larger, a center
mounting bracket is required. Remove
the screws from the center of the
middle or top housing and use them
to mount the center mounting bracket.
3. Remove one of the hinge screws from the
end of the hinge on the flip-up door assembly
4. Install the flip-up door onto the mounting brackets.
a. Pass the assembled hinge screw on the door through
the hole in either the left or right mounting bracket (use
the center bracket if the unit is 48" or larger).
b. Align the screw hole at the opposite end of the door
hinge with the hole in the mounting bracket.
c. Insert the hinge screw through the mounting bracket and
into the door hinge. Tighten the hinge screw until the
door is secure. Do not over-tighten.
NOTE: Apply thread locking compound to the removed hinge
screw before installation.
End
Cover
Left
Mounting
Bracket
End
Cover
Screw
End Cover
Screw
Flip-Up
Hinge Screw
Flip-Up Door Installation
Form No. GR2SDM-0920
Right Mounting
Bracket
Bracket
Hinge
Left Mounting
Bracket
Door
OPTIONS AND ACCESSORIES
Stainless Steel Divider Rods
Additional stainless steel divider rods are available to help
keep product separate in the channels.
Designer Inset Color Panels
Choose from several Designer colors to coordinate the inset
panels on the merchandising warmer to surrounding decór.
NOTE: This option is factory-installed only, not available for
retrofit.
Display Sign Holder
Advertise specials or showcase product with easy-to-use signs.
To install sign holder, follow these steps.
1. Attach strap clip brackets to sign holder brackets with
screws and cap nuts.
• Two hole positions on the sign holder brackets provide
angle adjustment. Select the desired holes for placement
on either a slant or horizontal unit.
Screw
Adjustment
Holes
Right Strap
Clip Bracket
Attaching the Strap Clip Assemblies
2. Position the strap clip brackets on top of the warmer and
carefully snap them over the top of the bull nose trim piece
on the front and rear of the warmer.
3. Insert a thin sign panel behind the clear panel provided.
Maximum total thickness is 1/4" (6 mm).
Strap Clip
Brackets
Bullnose
Trim Piece
Display Sign Holder
17
Sign Holder
Assembly
Cap
Nut
Left Strap
Clip Bracket
Sign Holder
Assembly