Use - gourmetmaxx CM-111A Mode D'emploi

Use

ATTENTION!
■ The device has overheat protection that prevents reactivation directly after the brew-
ing process for reasons of safety. Therefore, wait a few minutes after the brewing
process for the device to cool down before starting another brewing process.
■ Do not leave the device unattended so that you can immediately intervene in the
event of malfunctions (e.g. overfl owing etc.).
■ Caution: Risk of emitted steam! Never open the water tank cover when the device is
in use! Hot steam or hot splash water may escape.
■ Before start-up, make sure that the water tank cover is closed and the permanent
fi lter as well as the permanent fi lter holder have been correctly inserted so that the
water is able to circulate through the coffee powder/coffee pad without any obstruc-
tions.
■ Do not add any water to the coffee maker once it has been turned on. You could
scald yourself with the sudden emission of steam.
■ Never use the device with an empty water tank; the pump could be damaged if the
device is operated without water.
■ Do not overfi ll the permanent fi lter to prevent the fi lter from overfl owing.
■ Do not overfi ll the water tank to prevent the thermo cup from overfl owing! Always fi ll
the water tank with an amount of water that the cup (thermo cup etc.) located under the
coffee spout is capable of holding!
■ Place a cup or similar under the coffee spout before you connect the device to a
socket as the device will begin with the brewing process right away if the On button
has been pushed before the device was connected and the device is connected to
a socket.
1. Place the device on a dry, level and heat-resistant base.
2. Open the water tank cover and add some water to the water tank.
3. Place the permanent fi lter holder in the fi lter compartment.
4. Place the permanent fi lter in the permanent fi lter holder.
5. Add a coffee pad or loose coffee grounds to the permanent fi lter.
6. Close the water tank cover.
7. Place the thermo cup (without the cover!) under the coffee spout.
8. Connect the device to a properly installed socket that is easily accessible.
9. Push the On button to switch the coffee maker on. The On button will illuminate and
the brewing process will begin immediately.
10. The brewing process is complete when no more coffee fl ows into the coffee thermo
cup. The device automatically deactivates after the brewing process. The On button
will go out once the device is switched off.
11. Remove the thermo cup and put the cover onto the thermo cup. The lid has a drink-
ing aperture. Push the lid cover forward or backward to open or close the drinking
aperture.
12. After use, clean the device as described in the chapter "Cleaning and decalcifying".
17 EN