Setting Up The Dab Tuner - Teac NT-503DAB Mode D'emploi

Setting up the DAB tuner

The first time you listen to DAB radio, it will scan for DAB stations
and make a station list.
o You can also use the remote control ENTER button instead of the
main unit INPUT SELECTOR knob in the following steps.
o Some characters cannot be shown. Blanks will appear in place of
such characters.
1
Shift the POWER switch to its ON position to turn
the unit on.
2
Turn the INPUT SELECTOR knob to show DAB and
press the INPUT SELECTOR knob to select it, or
press the remote control TUNER button and press
the ENTER button.
DAB
Push [ENTER] Key
This sets the source to DAB.
o The first time that the unit is started and whenever there is
no station list, pressing the INPUT SELECTOR knob will cause
the following to appear.
No Station List
Push [MENU] Key
3
Press the MENU button to create a station list.
The unit will scan for broadcast services in the local area and
add them to the station list as they are found. The scan should
take about 20 seconds.
SCANNING...
xxx.xxx MHz
After broadcast services have been found, the stations are listed
in alphanumeric order.
o If no broadcast services are found, "No Station List Push
[MENU] Key" will be displayed. Check that the antenna is
correctly connected to the unit.
24
ATTENTION
The main unit and remote control MENU buttons and the main unit
INPUT SELECTOR knob are used for DAB function operations.
For this reason, if you press the main unit INPUT SELECTOR knob or
remote control ENTER button to enter DAB mode, ordinary operations
for changing menu items and input sources will be temporarily
disabled. (The input buttons on the remote control will still function.)
To return to ordinary operation mode, press the main unit INPUT
SELECTOR knob or remote control ENTER button again. (DAB
playback will continue unless the input source is changed.)