Teac NT-503DAB Mode D'emploi page 23

Masquer les pouces Voir aussi pour NT-503DAB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Playback from a Bluetooth device
o Pair this unit the first time you use it and when you want to con-
nect it with a new Bluetooth device (page 22).
o When pairing or connecting with another Bluetooth device,
they should be within a few meters of each other. If they are
too far apart, pairing and connection afterwards might become
impossible.
1
Turn the INPUT SELECTOR knob to select Bluetooth.
Bluetooth
SELECT DEVICE?
This sets the source to Bluetooth.
o You can also use the Bluetooth button on the remote control.
o Since the unit retains the same source mode when in
standby, this step can be skipped if the unit was in Bluetooth
mode when put into standby.
2
Enable Bluetooth transmission on the other
Bluetooth device.
3
Press the INPUT SELECTOR knob to show already
paired Bluetooth devices.
The bottom line of the display shows the name of the last con-
nected device.
o You can also use the ENTER button on the remote control.
Display example
Bluetooth
> Player_1
Name of last connected device
o The first 14 characters of the device name are shown.
o If no paired device is available, the display will appear as
follows.
Bluetooth
PAIRING?
Press and hold the INPUT SELECTOR knob to enter pairing
mode (page 22).
4
Press the INPUT SELECTOR knob to connect.
o If there are multiple paired devices, turn the INPUT SELECTOR
knob to show other devices. When the name of the device
that you want to connect is shown, press the INPUT
SELECTOR knob.
After connection, the display will show the input source.
Display example
Device name
Playe ORG DF OFF
aptX
Codec
o The first 5 characters of the device name are shown.
o If characters other than English letters and numbers are
included in the device name, it will not be shown properly.
V ATTENTION
Regardless of the connection status of this unit and the other
Bluetooth device, if the input source is not shown, restart both
this unit and the other device and then connect them again.
5
Start playback on the other Bluetooth device.
o Confirm that the volume is turned up on the other Bluetooth
device. If you do not turn up the volume on the playback
device, no sound might be output from this unit.
6
Turn this unit's VOLUME knob to adjust the volume.
o You can also use the VOLUME buttons on the remote control.
o Depending on the connected Bluetooth device, you might
not be able to adjust the volume. For details, refer to the
operation manual of that Bluetooth device.
Muting playback
If you want to temporarily mute the volume of this unit, press the
MUTE button on the remote control.
Press the MUTE button on the remote control again to return to the
previous volume level.
-41.5dB
23
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nt-503

Table des Matières