Using The Remote Control; Precautions For Use; Installing Batteries; When To Replace Batteries - Teac NT-503DAB Mode D'emploi

G
USB port (front)
Connect USB flash drives here.
o To play music files on a USB flash drive, set the input source
to NET and use the app for playback.
o Do not connect a computer to the USB port on the front of
the unit. To input audio from a computer, connect it to the
USB port on the back of the unit.
o For details, see the Network Manual.
H
PHONES jack
Connect headphones with a standard 6.3 mm (1/4") stereo
plug here (page 15).
o If headphones are connected to this unit, audio will not be
output from the analog audio outputs on the rear panel.
I
Display
This display shows information about the audio playing back
and menu screens.
J
VOLUME knob
Use to adjust the headphones output volume. Turn right to
increase and left to decrease the volume.
o To enable adjustment of this unit's analog audio output
volume, set LINE OUT LEVEL to VARIABLE ("Line output level"
on page 21). This will enable adjustment of the analog
output level using this unit's VOLUME knob.
o Volume settings are retained separately for analog audio
output and headphone output.

Using the remote control

Precautions for use

V Misuse of batteries could cause them to rupture or
leak, which might result in fire, injury or the stain-
ing of nearby materials. Please carefully read and
observe the precautions on page 5.
o When using the remote control, point it toward the remote con-
trol signal receiver on the main unit from a distance of 5 m (16 ft)
or less. Do not place obstructions between the main unit and the
remote control.
o The remote control might not work if the remote control signal
receiver on the unit is exposed to direct sunlight or bright light. If
this occurs, try moving the unit.
o Beware that use of this remote control could cause the unin-
tentional operation of other devices that can be controlled by
infrared rays.

Installing batteries

Remove the cover from the back of the remote control and insert
two AAA batteries with their ¥/^ ends oriented in the case as
shown. Replace the cover.

When to replace batteries

If the distance required between the remote and the main unit
decreases or if the unit stops responding to the remote buttons,
replace both batteries with new ones.
Dispose of the used batteries according to the instructions on them
or requirements set by your local municipality.
EN
13