Setup Menu Structure; Temperature Measurement Atc - Mtc; O 2 Parameter; O 2 Parameter Setup - VIO OXY 70 Manuel D'utilisation

• Setup Menu Structure

P5.0 DO SETTINGS
P8.0 LOG SETTINGS
P9.0 SETTINGS
Temperature measurement ATC – MTC
ATC : The direct measurement of the sample temperature for all parameters is carried out through the
•
NTC 30KΩ probe, integrated into the sensor.
MTC : If no temperature probe is connected, the value must be changed manually: keep pressed
•
or until the value starts to flash; then adjust it by continuing to use the directional keys; press
to confirm.
Note: with the optical sensor supplied together with the instrument, the manual temperature
compensation (MTC) IS NOT TO BE PERFORMED.
%O Parameter
2
Connect the optical sensor to the 6-pole multispin connector.
It is not necessary connect an external temperature probe, because it is already integrated.
Once switched on, the device does not require any polarization time. There, it is ready for use (calibration
and/or measurement).
• O parameter Setup
2
• In measure mode press
• Press the button
• Move with the keys
UM Serie Oxy70Vio EN rev.0 28.05.2020
P5.1
P5.2
P5.6
P5.7
P5.8
P5.9
P8.1
P8.2
P9.1
P9.2
P9.3
P9.4
P9.5
P9.8
P9.9
to access the SETUP menu.
to access the DO SETTINGS P5.0 menu.
and to select the program to access.
13
Cal 0
Salt Compensation
Cal Data
Set Due Cal
Reset Settings
Temp Cal
Data Logger Type
Clear Data
Temperature U.M.
Time and data Set
Backlight mode
Brightness
Sleep Mode
Reset Settings
Auto Power-Off
EN