Installation - VIO OXY 70 Manuel D'utilisation

Installation

• Supplied components
The instrument is always supplied inside the specific carrying case with these accessories:
batteries, adaptor 5V with USB cable, standard 0 oxygen, paper tissues, screwdriver, beacker, multilingual
user manual and test report. Contact your local distributor to be updated on the correct composition of the
sales kit and spare parts.
• Start-up
The device leaves the factory ready to be used by the user.
•
Batteries are included.
•
• Connection of the power supply
• in addition to batteries, the instrument can be powered through electricity grid;
• check that the electrical standards of the line on which the instrumentation is to be installed comply
with the voltage and operating frequency of the instrument;
• use the original power supply only;
• connect the power supply to the USB cable and the other end of the cable (Micro USB) to the Micro
USB port located on the front of the instrument;
Connect the power supply to an electric socket easy to reach.
•
ATTENTION - Danger of death or serious injury from electric shock.
Contact with live components can lead to injury or death.
• Use the adapter supplied only.
Do not put the power supply in contact with liquids nor in a condensing environment. Avoid thermal shock.
•
All electrical cables and connections must be kept away from moisture or liquids.
•
Check that the cables and plugs are not damaged, otherwise replace them.
•
• During use, do not cover the power supply and/or do not place it inside containers.
The electricity supply can be originated from the power grid and from the USB port of a PC too.
If the instrument is powered by PC, the icon indicating the battery status disappears from the display
Opening the DataLink+ software, on the display it is shown this icon
• Power on, date and time update, power off
Turn on the system by pressing the button
appears:
• Model and firmware of the instrument.
Settings relating to the most important parameters and possible information about the DHS sensor.
•
On first use, and after each battery replacement, the instrument during the start-up phase will request the
updating of the date and time.
Using the directional keys, update the year and confirm with the key
•
Carry out the same operation with the month and day, and subsequently with hours and minutes.
• The instrument will enter measure mode in the last parameter used.
• To switch off the instrument, press the key
UM Serie Oxy70Vio EN rev.0 28.05.2020
.
. The display initially activates all segments and then
in measure mode.
9
.
EN
.