Filter Replacement - Vornado AC350-EU Guide De L'utilisateur

FILTER REPLACEMENT

GENUINE VORNADO FILTERS ARE RECOMMENDED
Peak performance is only realized when genuine Vornado Carbon
and HEPA filters are used. Others may claim to be compatible with
Vornado units, but the Vornado Air Purifier is calibrated to achieve a
99.97% capture rate of particles 0.3 microns or larger, only when used
with Vornado Filters.
HOW TO REPLACE YOUR FILTERS
1. Unplug unit.
2. Remove Front Panel by lifting up and away from unit.
±
±
14 English
Note: The Front Panel is held in place by magnets, you will need to
lift the Front Panel hard enough to overcome the resistance of the
magnets.
3. Remove the Plastic Support Filter Frame by pulling on the center
tabs (A). You may need to flex the Plastic Support Filter Frame
slightly to release the tabs at the top and bottom.
A
² ² ² ² ² ² ² ² ² ² ² ² ² ² ²
² ² ² ² ² ² ² ² ² ² ² ² ² ² ²
4. Remove and discard used Filters. Simply take hold of the Carbon
Filter at any place along the perimeter and remove. To remove
the HEPA Filter, take hold of the tab (Figure 1) and pull to release.
Replace with genuine Vornado Filters. Place the Filters in the unit
and gently press around the perimeter of the Filter to ensure se-
cure placement (Figure 2).
Note: The HEPA Filter must be placed in the unit before the Carbon
Filter. See Product Information for a detailed illustration.
Fig. 1 Fig. 2
5. Replace the Plastic Support Filter Frame by securing the bottom
2 tabs into bottom slots (B). Slightly flex the Plastic Support Filter
Frame to secure the top 2 tabs into the top slots (A).
A
A
A
B
B
B
English 15