Seko TEKNAEVO TPG Manuel D'installation page 5

Display during Operation
Operating mode

mA
mA
Lev
Alarms and statuses

Lev = Level alarm

Flw = Flow alarm
Paragraph 3 - Dosage Proportional to Signal 20-4/0 mA
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
20-4/0 mA
20-4/0 mA
Low 20.0mA
-
20-4/0 mA
High 4.0mA
-
Display during Operation
Operating mode

mA
mA
Lev
Alarms and statuses

Lev = Level alarm

Flw = Flow alarm
Paragraph 4 – Proportional to External Impulses (multiplication)
Programming
PROG
Configuration
Pump Funtions
-
+
Pump Functions
Multiply (1:n)
Multiply (1:n)
n 4
-
Multiply (1:n)
Timeout 0s
-
Multiply (1:n)
Memory Off
-
EM00136061
FLOW sensor

status
(default: 4-20)
F F F 4-20
Stop P100%
Pump status

Empty = pump in start

Stop = pump stationary

Paus = pump in pause
The pump proportionally doses at a signal of 20-4(0) mA. On the basis of
the factory settings, the pump interrupts dosage at 20mA and doses at the
maximum set frequency when it receives 4 mA. These two values can be
modified during programming. The maximum frequency can be modified
during operation, by pressing the
-
+
increase the flow, or the
-
+
FLOW sensor

status
(default: 20-4)
F F F
20-4
Stop P100%
Pump status

Empty = pump in start

Stop = pump stationary

Paus = pump in pause
The pump doses in proportion to an external signal (i.e.: impulse launch
counter). With every signal received, the pump makes the programmed
"n" number of strikes. The pump automatically sets the dosage frequency,
adapting it to the time that passes between two successive signals. It is
possible to set the time (timeout) in seconds, beyond which the pump
resets the interval count in order to avoid dosages over excessively long
times. The pump has a memory function, which signals the reception of a
signal during dosage. If set to Off, it merely sends a signal, if set to On it
-
sends a signal and memorises the impulses, then executes them when it
+
has finished receiving signals.
-
The value of "n" can be modified during operation, by pressing the
+
-
+
decrease it.
Programmed value
Programmed interval value
Current dosage value
(depends on the selected unit
of measurement)

Percentage, Frequency,
l/h, Gph, ml/m
Programmed value
Programmed interval value
Current dosage value
(depends on the selected unit
of measurement)

Percentage, Frequency,
l/h, Gph, ml/m
keys at the same time to increase the flow, or the
rev. 2.1
Display during Setting (MODE key)
Operating mode

Displays the Low and High
value in sequence
Low
0.0 mA
Current dosage value

Makes it possible to modify the
maximum dosage value by pressing
the + or – buttons at the same time
Operation
keys at the same time to
keys to decrease it.
Display during Setting (MODE key)
Operating mode

Displays the Low and High
value in sequence
High
0.0 mA
Current dosage value

Makes it possible to modify the
maximum dosage value by pressing
the + or – buttons at the same time
Operation

Input mA
value
0
P100%

Input mA
value
0
P100%
keys to
4