Seko TEKNAEVO TPG Manuel D'installation page 3

You can access the programming menu by pressing the
be used to run through the menu items, with the
The pump is programmed in constant mode in the factory. The pump automatically returns to the operating mode
after 1 minute of no activity. Any data entered in these circumstances will not be saved.
The key can be used to exit the various programming levels. Upon exiting programming, the display will
show:
Exit
Don't Save
Paragraph 11
Paragraph 12
Paragrafo 13
Paragraph 9
Paragraph 2
Pump
Paragraph 3
Paragraph 4
EM00136061
Programmiermenü Tekna TPG
 
-
-
Paragraph 10
Paragrafo 1
-
Pump
Functions
Functions
Pump Functions
Paragraph 5
key for over three seconds. The
key being used to access changes.
Exit
Save
PROG
Paus
N.Open
Main
Menu
Configuration
Pump Funtions
+
Setting
Menu
Pump
Functions
Functions
Menu
Pump
Pump
Functions
rev. 2.1
to confirm the selection
+
Paragraph 17
Paragraph 16
Paragraph 15
Paragraph 14
+
Pump
Functions
Pump
Functions
Functions
Paragraph 6
keys can
Paragraph 8
Paragraph 7
2