Pentair Jung Pumpen BAUFIX 50 Instructions De Service page 8

ENGLISH
Installation of floor drain
1. Take out the 2 screws of the cover plate and remove it.
2. Take the plug out of the cover connection piece with a
screwdriver.
3. Screw the siphon with the union nut, the packing and the
expanding ring on the connection piece.
4. The outlet of the siphon must not be positioned directly
above the pump.
5. At using the stainless steel frame, grease the screws and
screw down the cover plate again.
Accessory alarm device
The alarm device signals an excessive high water level. It can
be installed subsequently. The cable is pulled through the vent
pipe and sealed in the same way as the pump cable. The alarm
unit should be connected to a separate electric circuit, to en-
sure the operation in case of a pump fault. Alternatively it can
be equiped with our 9V-rechargeable battery for off the line
operation.
Accessory special ventilation
If the ventilation over the roof level is not possible, alternatively
the special ventilation consisting of a ventilation screen and 3
activated carbon filters can be installed with a T-piece in the
cable pipe.
8
MAINTENANCE
The tank, the float switches and the foot strainer of the pump
should be inspected regularly and cleaned if necessary.
To service the pump, please refer to the separate operating
instruction.
NOTICE! Always grease the screws before using them to close
the cover plate and ensure the correct position of the profiled
seal.