Operation And Use; Filling The Appliance; Starting Ice Production - SilverCrest SEMK 105 A1 Mode D'emploi

Operation and use

Filling the appliance

CAUTION – PROPERTY DAMAGE!
► Never fill hot water into the water tank
be between 8 and 25°C .
NOTE
► Before filling the appliance, make sure that the cap is firmly in the drain
opening
will flow straight out again .
♦
Open the lid
♦
Use a container such as a measuring cup to fill the water tank
Never exceed the MAX marking .
♦
Replace the ice basket

Starting ice production

► Always use fresh drinking water to prepare ice cubes . Never reuse the
water from thawed ice cubes!
♦
Press the
The control lamp
♦
After around 7–15 minutes, depending on the water and ambient tempera-
ture, you will hear ice cubes start to fall into the ice basket
To remove ice cubes, open the lid
ice cubes using the ice scoop
♦
If the "Ice full" lamp
production is stopped and the appliance stops cooling . As soon as you
have removed enough ice cubes, the appliance will resume production .
♦
If the "Add water" lamp
Ice cube production is interrupted and the appliance stops cooling . If you
want to continue producing ice cubes, fill the water tank
the section "Filling the appliance" .
SEMK 105 A1
on the underside of the appliance . Otherwise, the filled water
and take out the ice basket
WARNING
button
lights up permanently green .
! The water temperature should
in the appliance and close the lid
to start ice production .
and remove the required amount of
. Then close the lid
lights up red, the ice basket
lights up red, the water fill level is too low .
.
.
.
.
again .
is full . Ice cube
as described in
GB │ IE │ 25 ■