EIBENSTOCK BST 300 V Notice Originale page 18

Inclined drilling
Drilling with Water
If you are cooling the drill bit with water a water collection ring is
recommended.
This will be mounted with a latch fastener on the screws of the base plate
and ensures a clean drilling. Mainly for overhead or lateral drilling. (see
spezial-accessories page 12)
Demounting the Core Drill Unit
Move the machine holder with the core drill upwards until it locks in the
final top position.
Remove the drill bit.
Drilling
Remove the bolt, which holds the
column at a 90° angle, from the
foot plate.
Loosen both Allen screws M10 with
the enclosed wrench SW 8.
Position the column in the
appropriate angle and tighten both
screws again.
After drilling put the column back in
the 90°position and lock it with the
screw.
BST 300 V : Furthermore, loosen the
locking lever on the bracing.
The scale on the toothed column makes
adjusting the drilling angle easier.
18