Publicité
Les langues disponibles
Les langues disponibles
Fastening by means of quick action bracing unit
In order to brace the drill rig by means of the quick action bracing
unit, the distance to the opposite wall must be between 1.7 m and 3 m.
H
G
Attention! It is important that the drill rig is firmly connected to the
surface. If not fixed correctly, injuries to the operator or damages to
the drilling unit may be caused.
drilling will cause the drill bit to hit the surface to be drilled which may
lead to a chipping of the segments. The drill bit might also tilt in the
bore hole which consequently will damage it.
Fixing the Core Drill Motor
Caution! When mounting the machine, risk of squashing.
Wear protective gloves!
Setting up the mounting plate
Position the drill rig. Position the quick action bracing
unit as close as possible behind the support on the base
of the rig. Fix the drill rig by turning the crank (G)
clockwise. Secure in position by means of the
appropriate bolt (H).
Move the machine holder upwards until it
locks in the top position.
Use the turnstile to open the locking device
of the mounting plate.
Remove it and connect it to the core drill
motor as described subsequently.
Uncontrolled movements during
16
Publicité
