Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Use; Switching On And Off - Parkside PASSK 20-Li A1 Traduction Des Instructions D'origine

Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Use

Switching on and off
Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in.
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦ Release the ON/OFF switch
appliance.
│ GB │ IE
■ 22
into the
and remove the
to
as follows:
lights up when the
is depressed lightly or fully.
to switch off the
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque preselection button
the required torque in stages.
♦ Press the ON/OFF switch
speed/tightening torque. Increasing the pres-
sure increases the speed/tightening torque.
■ The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
► However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening.
► The integrated motor brake ensures rapid
stoppage.
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!

Changing the direction of rotation

♦ Change the direction of rotation by pressing the
rotation direction switch
right.

Fitting the socket

♦ Push one of the supplied sockets
tool holder .
to select
lightly for a low
towards the left or
onto the
PASSK 20-Li A1