Pioneer PRA-BD11 Mode D'emploi page 18

Installation
16. Apply the supplied model number
labels to the front panel of the DVD
recorder and to the user registration
card.
1 Apply one of the two supplied labels to
the top left of the DVD recorder (see
accompanying illustration).
2 Attach the other model number label in
the model number label field on the US
user registration card (USA only).
Notes:
÷ Clean the area on the top of the front panel before attaching the model number label.
÷ The model numbers on the labels are unique for each unit, so be sure to apply the
correct label for the DVD recorder in which the unit is actually installed.
17. Operation check to verify connections
1Connect the video monitor to the video output and audio output connectors of the
DVD recorder (consult the Operating Instructions for the DVD recorder).
2Connect the DVD recorder's power plug to an electrical outlet, and set the power
switch (rear panel) to ON, the press the front panel's STANDBY/ON button to turn
the unit on.
[PRA-BD11 input board operation check]
1 Use a BNC cable (see page 6) to
connect the SDI input and AES/
EBU input connectors on the
input board installed in the DVD
recorder to equipment with SDI
and AES/EBU output connectors.
2 Output SDI and AES/EBU signals
from equipment connected in
Step 1.
3 Set the input on the DVD
recorder to SDI and AES/EBU.
÷
Press the FUNCTION
button on the DVD recorder
to open the Function Menu
on the video monitor. Use
the CURSOR and ENTER
button to select "SDI" as [V
Input] and "AES/EBU" as
[A Input].
18
PRA-BD11 / PRA-BD12
En
Attach model
number label here
Front panel of DVD recorder
Select "SDI" as [V Input] on the Function Menu.